3-10 Runs
Stopping a Run
The Stop key can be used to stop a run.
In the above procedure, after the Stop key was pressed the first time, the run could
have been resumed within the prespecified time (default is 10 minutes). This time is
the same pause time out discussed in “Pausing a Run” on page 3-9. The instrument
aborts the run automatically if the pause time out expires before you press F1 to
resume the run.
To stop a run before it completes:
Step Action
1 Press the Stop key.
The Confirm Stop screen appears.
2 Press the Stop key again to stop the run.
The run stops and the End of Run screen appears.
If any errors occur during a run, the following message appears: “Exception
occurred, check history file.” Press F1 (Hist) to review the history file. For more
information, see the following section.
3 Press F5 (Exit) to return to the Main Menu.
Sample 50.1
Confirm Stop
HOT
Press STOP to abort.
Press Resume to continue.
F1 F3 F4 F5F2
Resume
11:30 AM 25.1°C
Method:exp001
Run aborted at 11:30:05 AM 02/01/00.
Length of run is 01:34:25.
End of Run
F1 F3 F4 F5F2
Hist Exit