Arad Octave - Pulse

Octave Configuration Guide 27
Pulse
Mode – set the pulse’s accumulated volume output mode:
• “Disable” – output is disabled
• “Net” – pulse output is a measure of forward volume minus reverse
volume
• “Forward” – pulse output is a measure of forward volume
• “Reverse” – pulse output is a measure of reverse volume
Units – set the measuring units for the meter’s pulses:
• m
3
– cubic meters
• Ft
3
– cubic feet
• GAL – gallons
• IGAL – imperial gallons
• A.F. – acre feet
• A.I. – acre inch
• Barrel
Resolution – set the pulse resolution, i.e. the volume per one pulse, for the
selected measurement units:
• 0.0001
• 0.001
• 0.01
• 0.1
• 1
• 10
• 100
• 1000
• 10000