Arad Octave - Display Settings; Display Configuration

Octave Configuration Guide 10
4 Display Settings
Overview
The Display Settings tab is for configuring the Octave meter’s display (LCD).
Here you set the meter’s display units, number of digits following the decimal
point and mode, and also determine whether the meter’s display settings are
applied to the output stream of the connected module.
Display
Units - set the meter’s flow rate measurement units. The available
flow rate-volume unit combinations are:
• Flow Rate: m
3
/h - Volume: m
3
• Flow Rate: Lt / s - Volume: m
3
• Flow Rate: GPM - Volume: GAL
• Flow Rate: GPM - Volume: Ft
3
• Flow Rate: GPM - Volume: A.F.
• Flow Rate: IGPM - Volume: IGAL
• Flow Rate: GPM - Volume: A.I.