C.15 Option 34: NTP/PTP Server 177
::= { ntptrap 4 }
END
NTP MIB Object Definitions
• ntpSysLeap – two-bit code warning of an impending leap second to be inserted in the NTP
timescale.
• ntpSysStratum – indicating the stratum of the local clock. 0, unspecified; 1, primary
reference (e.g., calibrated atomic clock, radio clock); 2 – 255, secondary reference (via NTP).
• ntpSysPrecision – signed integer indicating the precision of the various clocks, in seconds
to the nearest power of two.
• ntpSysRootDelay – the total roundtrip delay to the primary reference source at the root
of the synchronization subnet, in seconds.
• tpSysRootDispersion – the maximum error relative to the primary reference source at the
root of the synchronization subnet, in seconds. Only positive values greater than zero are
possible.
• ntpSysRefId – the particular reference clock. In the case of stratum 0 (unspecified) or
stratum 1 (primary reference source), this is a pour-octet, left-justified, zero-padded ASCII
string. In the case of stratum 2 and greater (secondary reference) this is the four-octet Internet
address of the peer selected for synchronization.
• ntpSysRefTime – the local time when the local clock was last updated. If the local clock
as never been synchronized, the value is zero.
• ntpSysPoll – the minimum interval between transmitted messages, in seconds as a power of
two. For instance, a value of six indicates a minimum interval of 64 seconds.
• ntpSysPeer – the current synchronization source. Usually this will be a pointer to a structure
containing the peer variables. The special value NULL indicates there is no currently valid
synchronization source.
• ntpSysPhase – The system clock offset per selected source. (needs verification)
• ntpSysFreq – The system clock frequency correction per ntpd. (needs verification)
• ntpSysError – The current system error per ntpd? (needs verification)
• ntpSysClock – the current local time. Local time is derived from the hardware clock of the
particular machine and increments at intervals depending on the design used.
• ntpSysSystem – the type of local Operating System.
• ntpSysProcessor – the type of the local Processor.
To Next Page
Loading...
Need help?
General
