Arbiter Systems 1092A - Programmable Pulse - Pulse-Per-Day Mode; Pulse-Per-Day Setup

42 The Setup Menus
7.8.4 Programmable Pulse – Pulse–Per–Day Mode
Use the “Pulse–Per–Day” mode to generate a pulse every day, at the specified hour, minute, second
and fractional seconds. Refer to Section 7.8 above for additional detail on the Programmable Pulse
mode, and entering numerical values. For RS-232 command, see Section 10.2.12.
SET PROG. PULSE?
ENTER
SETUP
PROG. PULSE MODE?
PULSE PER DAY?
DOWN
UP
SET PULSE WIDTH?
PULSE WIDTH = 000.01
600.00
|
000.01*
SET PULSE TIME?
HOUR: 00
23
|
00*
SELECT UTC OR LOCAL?
PULSE TIME = UTC
LCL
UTC*
* = Default Setting
SET PULSE TIME?
MIN: 00
59
|
00*
SET PULSE TIME?
SEC: 00
59
|
00*
SET PULSE TIME?
.SEC: 00
99
|
00*
(-) POLARITY?
(+) POLARITY?
SLOW CODE LCL?
SLOW CODE UTC?
SINGLE TRIGGER?
PULSE PER DAY?
PULSE PER HOUR?
SEC. PER PULSE? *
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
Figure 7.12: Pulse–Per–Day Setup