Arbiter Systems 1092A - Setting Option Control; Option Control Setup

48 The Setup Menus
7.13 Setting Option Control
Use the “Set Option Control” menu to configure any main board or auxiliary board option mounted
in the clock. Some of these options require you to configure additional settings. For information
on configuring specific options see the Option List located in Appendix C. For RS-232 command,
see Section 10.2.15.
SET OPTION CONTROL?
ENTER
SETUP
MAIN BOARD OPTION?
NONE
19
NONE*
DOWN
UP
AUX. BOARD OPTION?
NONE
35
34
33
32
29
28
27
20A
03
NONE*
* = Default setting
Go to Options
List in Appendix C
for individual option
setup instructions
DOWN
UP
ENTER
ENTER
Figure 7.20: Option Control Setup