C.15 Option 34: NTP/PTP Server 149
Configure SNMP
Follow these instructions to configure SNMP operation in the Option 34. Figure C.24 illustrates
the different selections for enabling the service and selecting traps (notifications). For definitions
of SNMP “Configure” selections, see Section C.15.5.
Option 34 Network Time Module
Status
Configure
NTP
PTP
Clock
Network
System
Support
Logout
SNMP
Enable SNMP Service
Enable SNMP Traps
System Start
System Stop
Admin Login
Admin Logout
System Time Quality
System Time Set
System Time Change
Zero Satellites Visible
NTP Application Start
NTP Application Stop
PTP Application Start
PTP Application Stop
SNMP Application Start
SNMP Application Stop
Trap Receivers
IP Address 1
IP Address 2
IP Address 3
10.10.1.236
Apply Reset
Figure C.24: SNMP Configuration Page
Checking the box enables the specific item; unchecking disables the specific item in the SNMP
Configure page. For example, checking the “Enable SNMP Service” turns ON the service. Enabling
SNMP Traps and checking specific SNMP traps (or notifications) will not send any notification
unless a Trap Receiver is specified by an IP address. Make sure to click the Apply button or the
changes will be lost.