EasyManuals Logo

Arbiter Systems 1092A User Manual

Arbiter Systems 1092A
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Chapter 5
Setting Internal Jumpers
5.1 Introduction
Jumpers in the the 1092A/B/C and 1093A/B/C series clocks are normally set up at the factory
according default settings, or according to the purchase order if requested. If it should be necessary
to change any jumpers or to enable an alternate function, follow the instructions in this chapter.
5.2 Cover Removal
To change jumper configurations, the instrument cover must be removed. Remove top cover as
follows:
1. On all Models, disconnect the power cord. If equipped with Option 04 (power switch), first
turn the power switch to OFF.
2. Using a T-25 driver, remove the four screws securing the cover (and rack-mount ears, if used).
Lift the cover off.
5.3 Main Board Version
Figure 5.1 indicates important jumper and test point locations on the main board in the Model
1092A/B/C and 1093A/B/C. Use this drawing to assist you with locating the jumpers you may
want to configure. Jumpers are noted on the main board with a “JMP” prefix before the numbered
location. For example, jumper 3 would have a label of JMP3 on the main board. Table 5.1 lists all
of the current jumpers and their functions.

Table of Contents

Other manuals for Arbiter Systems 1092A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Arbiter Systems 1092A and is the answer not in the manual?

Arbiter Systems 1092A Specifications

General IconGeneral
BrandArbiter Systems
Model1092A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals