Arbiter Systems 1092A User Manual

10.2 Command Set 79
and times. To complete the Daylight Saving / Summer Time setup, you must also use the “Set
Daylight Saving Auto Start” and “Stop” commands that follow below.
Response: C
Set Daylight Saving/Summer Auto Start Time
Command: 2,w,x,y,zDT
2,w,x,y,zDT sets the starting (Start) date and time for Daylight Saving / Summer Time AUTO
setting.
Where: w = Month (0 through 11), with 0 = Jan, 1 = Feb, ... 11 = Dec.
x = WeekOfMonth (0 through 5), with 0 = First, 1 = Second, 2 = Third,
3 = Last, 4 = Second from Last, and 5 = Third from Last.
y = DayOfWeek (0 through 6), with 0 = Sun, 1 = Mon, . . . , 6 = Sat.
z = Minutes after midnight z (0 through 1440).
Response: C
Set Daylight Saving/Summer Auto Stop Time
Command: 3,w,x,y,zDT
3,w,x,y,zDT sets the ending (Stop) date and time for Daylight Saving / Summer Time AUTO
setting.
Where: w = Month (0 through 11), with 0 = Jan, 1 = Feb, . . . , 11 = Dec.
x = WeekOfMonth (0 through 5), with 0 = First, 1 = Second, 2 = Third,
3 = Last, 4 = Second from Last, and 5 = Third from Last.
y = DayOfWeek (0 through 6), with 0 = Sun, 1 = Mon, . . . , 6 = Sat.
z = Minutes after midnight z (0 through 1440).
Response: C
Local Offset Command
Command: ±hh:[mm]L
±hh:[mm]L sets the local offset in hours and fifteen-minute increments from -12:00 to +12:00, where
hh and mm equals the number of hours and minutes, positive (East) or negative (West).
Response: C
10.2.7 Front Panel Control Commands
Disable Control Panel
Command: FB
FB disables all control–panel keys and blanks the front panel display – Models 1092B and 1093B/C
only.
Response: C

Arbiter Systems 1092A Specifications

General

Brand	Arbiter Systems
Model	1092A
Category	Measuring Instruments
Language	English