EN – 19
DRIVE IDLER ASSEMBLY
REPLACEMENT
Remove Attachment Drive Idler Assembly
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove auger housing. See Separate Housing From
Frame on page 7.
4. Remove attachment brake spring from frame. See
Figure 33.
See Figure 34.
5. Remove torsion spring from attachment idler arm.
6. Remove tapping screws retaining attachment idler
arm to hub and remove idler assembly.
Remove Traction Drive Idler Assembly
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove attachment drive idler assembly. See
Remove Attachment Drive Idler Assembly on page 19.
See Figure 35.
4. Remove tension spring from traction drive idler arm.
5. Remove roll pin and attachment idler arm hub from
drive idler pivot rod.
6. Remove torsion spring from idler pivot rod.
7. Remove traction idler arm assembly from pivot rod.
See Figure 36.
To Next Page
