Ariens 921049 - Install Auger; Deluxe

EN – 26
See Figure 54.
7. Remove traction drive clutch cable and return spring
from swing gate.
IMPORTANT: To gain more cable slack, traction drive
clutch cable may need to be removed from traction clutch
lever. See Figure 86.
8. Remove three hairpins and one flat steel washer from
pivot rod and remove pivot rod. See Figure 55.
9. Remove swing gate assembly. See Figure 56.
Install Swing Gate Assembly
1. Position swing gate assembly inside frame and align
with pivot rod holes.
2. Reinstall pivot rod through swing gate and secure with
one flat steel washer and three hairpins. See
Figure 57.
Figure 54
1. Traction Drive Clutch Cable
2. Return Spring
1
2
Figure 55
WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
Figure 56
Figure 57