Arkon MAGX2 - Page 11

MAGX2 User Guide
10
V2.14 1-2-2017
Sensor communication module version 8.0
Use this cable connection only for “sensor to
transmitter communication module – version 8.0”.
“Please note that in different versions of the transmitter, 2 types of connections can be
used. These are 1 x 4-pin connector instead of a 2 x 2-pin connector as shown in the picture.”
Important: In case of IP68 transmitter it is needed to use silicone gel to extra protect cable glands from inside
of the meter. Pour neutral silicone gel into the cable gland from inner side and pull the cable 3mm out of the
housing to make the cable gland extra protected for IP68.