2.4. Installation of the transmitter
In case of a compact flowmeter version, the transmitter will need no further installation, and should be ready
for use. In case of a remote version, the following 4 steps are necessary.
Mount the transmitter to a wall, panel, or DIN-rail.
Wall mounting:
DIN-rail mounting:
Panel mounting:
Connect the transmitter to the signal cable from the sensor.
IP67 Transmitter
To do this, first open the transmitter housing by disconnecting the two parts of the transmitter housing with the
metal “key” that is provided with the meter
IP68 Transmitter
To do this undo four M6x22 screws using allen key nr.5 that is part of the delivery.
To Next Page
Loading...