Contents
Open Access
iv
ARM Development Board (ARM7TDMI Version)
Hardware Reference Guide
ARM DUI 0017C
5 Expanding and Monitoring the APB 5-1
5.1 APB Expansion Interface 5-2
5.2 Building an APB Slave Expansion Board 5-5
5.3 APB Timing on the ARM Development Board 5-6
6 The EmbeddedICE Interface 6-1
6.1 EmbeddedICE Interface 6-2
7 The Logic Analyser Interface 7-1
7.1 ARM HP Inverse Assembler 7-2
8 The Test Interface 8-1
8.1 Introducing the Test Interface 8-2
8.2 Connecting External Equipment to the Test Bus 8-3
8.3 Test Interface Interconnections 8-4
9 Programming the APB FPGA 9-1
9.1 Introduction 9-2
9.2 Interrupt Controller 9-3
9.3 Using the APB FPGA in Your Own Designs 9-4
10 Programming the MACH and PAL Devices 10-1
10.1 Reprogramming a Device 10-2
A Board Schematics A-1
A.1 Card Outline Drawing A-2
A.2 Top-level Diagram A-3
A.3 Power Supply A-4
A.4 Crystal Oscillator and Clock Distribution A-5
A.5 ASB Slaves A-6
A.6 “On-chip” Memory (Synchronous SRAM) A-7
A.7 EPROM/FLASH ASB Slave A-8
A.8 DRAM ASB Slave A-9
A.9 SRAM ASB Slave A-10
A.10 APB and NISA Bridge A-11
A.11 NISA Bus Peripherals A-12
A.12 Serial and Parallel Ports A-13
A.13 PC Card Interface A-14
A.14 PC Card Connecters and Power Supply A-15
A.15 APB Slaves A-16
A.16 APB Expansion Connecters A-17
A.17 APB Buffers A-18
A.18 Memory Address and Data Buffers A-19
hrg.book Page iv Wednesday, July 22, 1998 9:18 AM
To Next Page
Loading...
