CHAPTER 2 CONTROLS AND DISPLAY
EFD1000 PRO MAX PFD Pilot’s Guide
Page 2-22
091-00005-002 () EFD1000 PRO MAX PFD Pilot’s Guide
Page 2-23
091-00005-002 ()
2.7 Range Buttons
When the MAP is enabled, the RNG (Range) Button is used to zoom the map in or out.
Press the RNG (+) Button to increase map range. Press the RNG (-) Button to decrease
map range. Additionally, an Auto Range control feature is available.
Pressing and holding either the RNG (+) or (-) Button will cause the map range to scale
continuously to its maximum or minimum range, respectively. When the map range is
at its maximum or minimum setting, release and then press and hold the RNG Button
again to activate the Auto Range control mode.
2.8 REV Button
The red REV Button on the PFD can be used to override automatic power control in
abnormal or emergency situations. The PFD is typically powered through an PFD master
switch that is connected to the aircraft’s Battery bus. Normally, the PFD will power down
when the PFD Master switch is turned OFF or when aircraft power is removed when on
the ground. To force the PFD to power down, the following procedures are provided.
To Shut Down
1. Press and hold the REV Button until the display turns off
Or
1. Press the MENU Button.
2. Rotate the Right Knob to the POWER SETTINGS Menu page
3. Press the SHUT DOWN Menu Key
A powering off annunciation displays indicating that the unit will shut down in
5 seconds. The pilot can press any control to abort the power-down sequence.
Power On Manually
• Press and hold the REV Button until the PFD powers on.
To Next Page
Loading...
