CHAPTER 4 REFERENCE GUIDE
EFD1000 PRO MAX PFD Pilot’s Guide
Page 4-15
091-00005-002 ()
NOTE
Since the altitude tape display is limited to
approximately 400 feet, the altitude bug symbol
is shown on the altitude tape when the Selected
Altitude Field value is within the visible range of
the current altitude.
Set Barometric Units of Measure
1. Press the MENU Button.
2. Rotate the Right Knob to select the GENERAL SETTINGS B page (Figure 4-19).
3. Press the BARO Menu Key. The Menu label turns magenta, and the EDIT
VALUE label displays above the Right Knob (Figure 4-19).
4. Rotate the Right Knob to select either in or mB (Figure 4-20 and 4-21).
5. Press the MENU Button to exit.
4.3.2 Selected Altitude & Alerting
The Selected Altitude is displayed at the top of the Altitude Tape. The Selected Altitude
Field range is 100 to 51,000 feet, in 100 foot increments. Additionally, the Altitude Bug
is displayed adjacent to the Altitude Tape and at the Selected Altitude Field value when
within the visible range of the current altitude.
Set Altitude Bug
1. Press the Right Knob until ALT displays above the Right Knob. The Selected
Altitude Field and bug are enabled for editing, all rendered in magenta
(Figure 4-22).
2. Rotate the Right Knob (clockwise to increase, or counterclockwise to
decrease) to change the value of the Selected Altitude Field. Rotating the
knob quickly will change the altitude in larger increments
3. Once the correct value is selected, and after 10 seconds of inaction, the
field is disabled, and the label, field, and bug are rendered in cyan.
Figure 4-22
Altitude Bug and Altitude Alerter Enabled
Figure 4-23
Altitude Alert
To Next Page
Loading...
