CHAPTER 4 REFERENCE GUIDE
EFD1000 PRO MAX PFD Pilot’s Guide
Page 4-12
091-00005-002 ()
Hide/Display Airspeed Tape
In some configurations, such as a stand-alone PFD, the airspeed tape can be turned
off at the pilot’s discretion to facilitate screen declutter. When turned off, the numerical
display of Selected Airspeed remains. This setting will be retained when the PFD system
is turned off then powered on again.
1. Press MENU Button.
2. Rotate Right Knob until first Menu Key displays TPS (Figure 4-16).
3. Press TPS Menu Key. TPS label and EDIT VALUE label (above Right Knob)
appear in magenta.
4. Rotate Right Knob to the desired value: ENABLE or DISABLE (Figure 4-17).
NOTE
A typical installation sets the Tapes (TPS) display
to UNLOCKED, allowing the pilot to display or
hide the Airspeed and Altitude Tapes as desired. If
the Airspeed and Altitude Tapes were LOCKED ON
during installation, the Tapes will remain on. If the
Airspeed and Altitude Tapes were LOCKED OFF during
installation, the Tapes will not display.
Figure 4-16
Editing Airspeed Tape Display
Figure 4-17
Airspeed Tape Disabled
To Next Page
Loading...
