D11 7
leveling cylinder in AUTO
mode, screed floating, screed
loading / unloading, paver
finisher break release.
Reverse position: paver finisher
break release.
7 Ignition switch
To activate the ignition voltage
by turning the key.
-Switch off by turning the key
back to its starting position.
After energizing, screen and
control panel will take some
time to inspect and load the
correspinding application
programs.
On shutting off the vechicle,
first switch off the ignition, then
deactivate the main switch.
Before the main switch is
deactivated, a period 10
seconds must elapse after
switching off the vehicle.
9 Screed vibration lever
Pushbutton function:
-Activate screed vibration
(“AUTO” or “MANUAL”)
For triggering screed vibration,
screed vibration switch must be
switched to “AUTO” or
“MANUAL”.
Screed vibration speed under
“MANUAL” mode is equal to the
highest speed under “AUTO”
mode.
To work under “AUTO” mode,
drive lever must be put into
To Next Page
Loading...
