Atlas Copco Dynapac F3030C - Page 81

D11 19
forward postion.
Speed of conveyor is controlled
by limit switch inside material
level sensor.
To avoid material overload,
conveyor would stop working
when material level exceeds
limit.
On actuation, note danger
zones of moving parts of the
vechicle!
23
Screed floating position control
switch
Pushbutton function:
This button is two gear
unresettable button.
-Button is at upper position:
Screed floating function off,
screed can be lifted or lowered.
-Button is at lower position and
drive lever is at forward
position:
Activate screed floating
function, screed is at floating
position.
27 Button 1 function on display
See from display section; select
the menus assigned in display
area to switch commands.
28 Button 2 function on display
See from display section; select
the menus assigned in display
area to switch commands.
29 Button 3 function on display
See from display section; select
the menus assigned in display
area to switch commands.
36 Left screed extend/retract switch
Botton at left position: the left
side of telescoping screed
extending to the outside;