Atlas Copco FlexiROC T30 R - Specifications; Standard Tightening Torques Bolted Joints; Type Designation Signs for Ordering Spare Parts

FlexiROC T30 R 3 Specifications
13 No: 3629357835.1.3629419915 en-US
3 Specifications
3.1 Standard Tightening Torques Bolted Joints
All bolted joints are tightened to the torque required by Atlas Copco Standard K 4369:01 K
(metric) and 4368K/-01K (imperial) unless otherwise stated. In such cases, this torque is
specified in the maintenance instructions of the module in question.
Size Strength Class Torque in Nm Tolerance ±
M6 8,8 8 2
M8 8,8 20 5
M10 8,8 41 10
M12 8,8 73 18
M14 8,8 115 25
M16 8,8 185 45
M20 8,8 355 85
M24 8,8 600 150
M12 x 1.25 10,9 135 6
M16 x 1.25 10,9 315 15
M18 x 1.25 10,9 460 20
M6 12,9 14 3
M8 12,9 34 8
M10 12,9 70 17
M12 12,9 120 30
M14 12,9 195 45
M16 12,9 315 75
M20 12,9 600 150
M24 12,9 1020 250
Table1: Atlas Copco Standard Torques
3.2 Type Designation Signs for Ordering Spare Parts
Type designation signs are posted on the larger components. The type designation and se-
rial number must always be stated when ordering spare parts or making inquiries regarding
the machine. Type designations and serial numbers are also specified in a separate docu-
ment, MI (Machine Identification). Spare parts can be ordered from Atlas Copco.