FlexiROC T30 R 21 Downtime
138 No: 3629357835.1.3629419915 en-US
2.
Apply corrosion inhibitor (For example, Tectyl 506) to the machined surfaces.
3.
Apply touch-up paint to any scratches and damage on painted areas.
21.1.4 Preparing Water Mist System for Long Time Storage
1.
Drain the water mist system.
2.
Rinse with anti-freeze.
3.
Blow dry the water mist system with compressed air.
21.2 Restoring After Long Period of Downtime
n Change lubricant and hydraulic oil where appropriate.
n Change filter and drain water separators where appropriate.
n Inspect joints, bushings and splines for corrosion. Remedy any corrosion by cleaning
or replacing components.
n In order to remove any moisture binding from lubrication points: Pump new grease into
the grease nipples and apply grease with a brush to sliding surfaces and splines where
these occur. Use the correct grease for each point.
n Carry out special startup as instructed.
21.3 Inspection and Maintenance During Period of
Downtime
n Check levels for oils and coolants.
n Start the diesel engine and run until the normal operating temperature is reached.
n Operate the machine a few metres back and forth so that the tramming gears are lubri-
cated.
n Operate the tilt cylinders, boom, feeder, drill rod support, and rod handling until all
cylinders reach their end positions.
n Drain condensed water from the hydraulic oil tank and compressor oil tank.
n Rotate the electric motors a few turns at least every three months to avoid spot dam-
age on motor bearings.
To Next Page
Loading...
