Atlas Copco FlexiROC T30 R

FlexiROC T30 R 7 Feed Unit
46 No: 3629357835.1.3629419915 en-US
7.
Check the play between the jaws and the drill rods.
8.
Loosen the bolts holding the drill rod support.
9.
Adapt the drill rod support position until the play is around 1 mm.
10.
Fasten the bolts.
11.
Open the drill rod support.
12.
Close the drill rod support.
13.
Check the play between the jaws and the drill rods.
7.26 Pressure Setting
1.
Connect a pressure gauge to the test outlet at the valve (Y350).
2.
Start the pumps and close the drill rod support.
3.
Adjust maximum pressure to approx. 80 bar.
7.27 Check Drill Rod Support BSH-XS
n
Check tightness of the bolted joints.
n
Check or adjust drill center.