Atlas Copco FlexiROC T30 R - Check Boom Condition

FlexiROC T30 R 6 Boom Unit
20 No: 3629357835.1.3629419915 en-US
6.2 Check Boom Condition
n
Check the mounting on the boom head (A). Tightening torque 73 Nm (54 lbf.ft).
n
Check the clearance between the feed and feed bracket (B). Clearance 2-4 mm.
n
Check the mounting on the feed bracket (C). Tightening torque 185 Nm (136 Ibf.ft).
n
Check the clearance between the bushings, shaft and holder (D). Replace the bush-
ings and even the shaft if necessary.
n
Check clearance on the bearings in cylinder lugs (E). Maximum clearance 1 mm.
n
Check mounting, damage. 11 plates on locking plates (F). Tightening torque 73 Nm
(54 lbf.ft).