To Next Page

To Previous Page

Operating Instructions Xenotest

150 S+

• tight connection and possible leakage of water hoses,

• condition of the water filter,

• filling level of the instrument-integral water reservoir or of the supply reservoir

for treated water,

• condition of connector and power supply cable.

6.3 Installation and removing the xenon lamp

WARNING - Electric shock!

Contact with voltage-carrying components may cause a lethal

electric shock. The irradiator ignition system is under high voltage.

Prior to removing / installing the xenon lamps, disconnect the in-

strument from the power supply system!

• Switch the instrument off using the ON/OFF switch.

• Disconnect the mains plug from the socket and protect it from acci-

dental reconnection.

• Check to see if the instrument is de-energized.

CAUTION - Risk of burns!

The components of the irradiation unit reach extremely high tem-

peratures; contact with skin may cause burns.

Prior to replacing the xenon lamp, allow the irradiation unit com-

ponents to cool down sufficiently!

NOTE - Handling the xenon lamp:

Residues from finger contact may burn into the xenon lamp glass

tube and cause uneven irradiation.

• Grasp the xenon lamp only at the lamp socket.

• Wear clean cotton gloves for installation.

6 Start-up

Atlas XENOTEST 150 S+ User Manual

Questions and Answers: