Atlas XENOTEST 150 S+ User Manual

Operating Instructions Xenotest
®
150 S+
50
8.1 Switching the instrument off
The instrument can be switched off after completion or
interruption of a test program.
Switching the instrument off after completion of a test
program:
• After the instrument has cooled down, move the
master switch to position "0".
Interrupting a test program and switching the
instrument off:
1. To interrupt the program run:
Press thekey
2. Fig. 35: After the instrument has cooled down, move the
master switch to position "0".
8.2 Emergency shut-off
• Fig. 35: Move the master switch to position "0".
8.3 Removing samples
CAUTION - Risk of burns!
The samples are extremely heated during
a test program run.
Contact with heated samples may cause
burns.
To remove samples, wear protective gloves!
Removing samples:
1. Switch the instrument off.
2. Open the test chamber door.
3. Allow the samples to cool down sufficiently.
4. Remove the samples carriers from the retainers.
8 Shut-down
Fig. 35

Atlas XENOTEST 150 S+ Specifications

General

Brand	Atlas
Model	XENOTEST 150 S+
Category	Laboratory Equipment
Language	English