Atlas XENOTEST 150 S+ User Manual

Operating Instructions Xenotest
®
150 S+
36
6.6 Installing / removing optionale sensors
Sensor types, Fig. 22:
For the Xenotest
®
150 S+, 3 sensor types are available for
measured-value acquisition purposes.
1 XenoCal BB 300-400
2 XenoCal BST
3 XenoCal WST
XenoCal BB 300-400 (ID No. 55007863):
Broad-range sensor for calibration, adjustment, and measu-
red-value acquisition (via IBM-compatible PC) of irradiance
(W/m²) and irradiance (kJ/m²) within the wavelength range
of 300 - 400 nm (UV).
XenoCal BST (ID No. 55007861):
Temperature sensor for the electronic acquisition, calibrati-
on, and adjustment of black standard temperature at sample
level.
XenoCal WST (ID No. 55007862):
Temperature sensor for the electronic acquisition of white
standard temperature at sample level.
NOTE - Detailed information:
For detailed information about the use of
the XenoCal sensor, refer to the sensor's
separate operating instructions which are
included in the XenoSoft software.
The sensors are installed in the test chamber using the sen-
sor adapter 4 and the sensor mounting bracket 5.
6 Start-up
Fig. 22

Atlas XENOTEST 150 S+ Specifications

General

Brand	Atlas
Model	XENOTEST 150 S+
Category	Laboratory Equipment
Language	English