PREPARATION
Power requirements
33
J
How to Reset a Tripped Breaker (for DC Power)
If an overcurrent condition occurs during use, the breaker is activated (tripped) to interrupt the power sup-
ply in order to prevent accidents. Follow the steps below to reset the tripped breaker.
(1) Press the
switch to turn the power off.
(2) Wait for at least one minute after the breaker has
been tripped before pushing the breaker switch to
the “ON” position.
ON
OFF
(3) Press the switch to turn the power on.
z
To avoid failures, wait for at least one minute or so
after the breaker has been tripped, and then push
the bottom.
z
If the reset breaker is tripped again, stop using it
and contact your local Atom representative.
To Next Page
Loading...
