AuCom EMX4i - Page 95

PROGRAMMABLE PARAMETERS
94 EMX4i User Manual 710-14888-00C
Pump Pressure
The pressure at the pump, as configured in
parameters 30B~30D. This information is
only available if the smart card is installed.
Pump Flow
The flow at the pump, as configured in
parameters 30F~30K. This information is
only available if the smart card is installed.
Well Depth
The depth of the well, as configured in
parameters 30M~30O. This information is
only available if the smart card is installed.
Pump
Temperature
The pump temperature, as measured by the
PT100. This information is only available if
the smart card is installed.
Analog Output
Value
The value of the analog output (refer to
parameters 9A~9D).
Heatsink
Temperature
The soft starter's temperature, measured at
the heatsink.
Bypass Model (%)
The percentage of thermal capacity
remaining in the bypass contactor.
SCR
Temperature
The temperature of the SCRs, calculated by
the thermal model.
Rating Capacity
(%)
The thermal capacity available in the soft
starter for its next start.
Description:
Selects which information will be displayed on the main
monitoring screen.
10I – User Parameter 2
Options:
Refer to parameter 10H User Parameter 1 for details.
Default:
Motor Voltage
Description:
Selects which information will be displayed on the main
monitoring screen. Refer to parameter 10H
User Parameter 1
for details.
10J – User Parameter 3
Options:
Refer to parameter 10H User Parameter 1 for details.
Default:
Mains Frequency
Description:
Selects which information will be displayed on the
programmable monitoring screen. Refer to parameter 10H
User Parameter 1 for details.