Triangles indicate the activation:
Triangle pointing in upward direction: Output is coded high active.
High active (voltage is present, e.g. + 24 V DC)
High active (voltage is not present)
Triangle pointing in downward direction: Output is coded low active.
Low active (voltage is not present)
Low active (voltage is present, e.g. + 24 V DC)
Signals for simulating analogue outputs:
Signals AOUT 1
Simulation of output signal Actual position, setting range: 0 ... 20 mA
Signals AOUT 2
Simulation of output signal Torque, setting range: 0 ... 20 mA
124
Actuator controls
Diagnostics AC 01.2/ACExC 01.2 Profinet
To Next Page
Loading...
