E
Electronic device ID 118
Electronics monitoring power
supply
101
EMERGENCY behaviour 77
EMERGENCY operation 77, 80
EMERGENGY stop 32
Enable functions 105
Enable operation commands 85
Enabling local controls 82
End position seating 34
End position tolerance 53
Enforce REMOTE control 84
Error - indication on display 18
Error variable 52
Event report 126
F
Factory setting 114
Fail safe (diagnostic) 122
Failure behaviour 75
Failure functions 75
Failure - indication on display 22
Failure operation 75
Failure position 76
Failure source (EMERGENCY
operation)
79
Failure source (failure opera-
tion)
76
Failure source (Interlock) 86
Fault - indication on display 21
Fault signal - configurable 25
Fieldbus auto enable 85
Fieldbus failure 65, 65, 85
Firmware update 116
Firmware version 116
FQM (diagnostics) 122
Function check - indication on
display
21
Functions: activate/enable 105
Fuses 135
G
Gear reduction ratio 107
H
Heater 102
Heater in switch compartment 73
Heater monitoring 102
Heater monitoring time 103
Heater on control unit 73
Heater system 102
Heater system monitoring 102
Histogram 130, 131, 132
Histograms 130
Home port 108
I
I/O interface change-over 65
Incorrect entry 15
Indication light colour 23
Indication lights 23
Indications 17
Indications on display 17
Input of setpoint position 55
Interface (diagnostics) 119
Interlock: 85
Interlock: by-pass 82
Interlock behaviour 87
Intermediate position indica-
tion via LEDs
23
Intermediate positions 47
Internal process setpoint 60
Intrusive 10
Inverse operation 59
L
Language in the display 15
LEDs (indication lights) 23
Lift Plug Valve 68
Limit seating 34
Limit setting range 53
Limit switching 37
Local actuator operation 11
Local control 11
Local controls 11
Local setting 12
Local Stop 87
Local stop: by-pass 82
Loss of process setpoint 59
Loss of signal 75, 76
Loss of signal (fieldbus) 65, 85
Loss of signal process set-
point
59
LPV 68
151
Actuator controls
AC 01.2/ACExC 01.2 Profinet Index
To Next Page
Loading...
Need help?
General
