102
NOTE
The MaxiSys Printer runs automatically after the installation. The PC, printer, and the
tablet must be connected to the same network.
This section describes how to receive files from the tablet and perform printing through
the PC.
NOTE
⚫ Make sure the tablet is connected to the same network with your PC, either via
Wi-Fi or LAN, before printing.
⚫ Make sure the PC installed with the Printing Services program is connected to a
printer.
➢ To perform printing through the PC
1. Run the PC Link program on the PC.
2. Select the MaxiSys Printer tab.
3. Tap the Print button on the top toolbar of the tablet. A test document will be
sent to the PC.
If the Auto Print option in the MaxiSys Printer is selected, the MaxiSys
Printer will print the received document automatically.
If the Auto Print option is not selected, click the Open PDF File to view
all the temporary files. Select the file(s) needed for printing, then tap
Print.
NOTE
To confirm that the printer is functioning normally, you can click Test Print in the PC
Link program to test.
10.4 Report Settings
Two options are available in this section: Scan Report and Report Upload to Cloud.
⚫ Scan Report
Toggle the ON/OFF button to enable/disable Pre-Scan and Post-Scan functions,
which enable the user to compare the changes between pre-scan and post-scan.
For more information about the pre-scan and post-scan functions, see Pre-Scan
and Post-Scan Functions on page 82 for details.
⚫ Report Upload to Cloud
This option automatically synchronizes the diagnostics information of the vehicle to
the vehicle history and forms a diagnostic report for the user to upload. Tap the
ON/OFF button to enable/disable the Report Upload to Cloud function. The button
appears blue if the function is enabled and displays gray if the function is disabled.
To Next Page
Loading...
