82
5.7.2.7 Vehicle Information
The option displays the vehicle identification number (VIN), the calibration identification,
and the calibration verification number (CVN), and other information of the test vehicle.
5.7.2.8 Vehicle Status
This function checks the current condition of the vehicle, such as the communications
protocols of OBDII modules, quantity of fault codes, and the status of the malfunction
indicator light (MIL).
5.8 Diagnostic Reports
5.8.1 Pre-Scan and Post-Scan Functions
After performing pre-scan and post-scan functions by entering the same maintenance
order number, tap Data Manager > Vehicle History to select the historical test record
named with the maintenance order number. Both the pre-scan results and post-scan
results will be displayed in the same historical test record, which can be generated as a
PDF report for easily comparing the changes between pre-scan and post-scan.
⚫ Pre-Scan Function
Select and tap a vehicle button from the Vehicle Menu screen. Enter the
maintenance order number in the pop-up box to scan and detect the whole vehicle.
You can also add pictures to record the current condition of the vehicle. Once the
pre-scan is completed, you are not allowed to perform pre-scan again, and the
scan result cannot be modified.
⚫ Post-Scan Function
After the pre-scan is complete, exit the current test vehicle and tap the vehicle
button from the Vehicle Menu screen to reconnect again. Enter the same
maintenance order number in the pop-up box. The screen for post-scan will display.
The post-scan record will be generated when the scan is completed. The pre-scan
results and post-scan results will be displayed in the same historical test record.
NOTE
The post-scan function can be performed repeatedly. After exiting the vehicle, you only
need to tap the vehicle button from the Vehicle Menu screen to reconnect again, then
enter the same maintenance order number in the pop-up box and follow the steps to
rescan. The last post-scan result is the final one.
To Next Page
Loading...
