Autel MaxiTPMS TS900 - No Communication Message

51
A BT badge will display at the bottom-right corner of the VCI Manager shortcut, which
means the communication of MaxiVCI V150 and TS900 tablet has been established,
and the tablet is ready to start vehicle diagnosis.
Refer to VCI Bluetooth Pairing on page 97 for details.
5.1.3 No Communication Message
A. If the tablet is not connected to the MaxiVCI V150 correctly, an “Error” message
may display. This indicates that the tablet cannot access the vehicle control
module. In this case, please do the following check-ups:
⚫ Check if the MaxiVCI V150 is powered up.
⚫ Check if the MaxiVCI V150 is properly positioned.
⚫ Check if the Power/Connection LED on the MaxiVCI V150 is illuminated for
Bluetooth connection.
⚫ Check that the network is configured correctly or that the right MaxiVCI V150
has been paired up with the tablet.
 During the diagnosis process, if the communication is suddenly
interrupted due to the loss of signal, check if there is any object that
causes signal interruption.
 Try standing closer to the MaxiVCI V150 to obtain more stable signals
and faster communication speed.
⚫ Check if the Power/Connection LED on the MaxiVCI V150 lights solid red and
blue (connected via Bluetooth) or solid red and green (not connected) when
there is something abnormal, and if so, it indicates there is something
abnormal with the MaxiVCI V150. In this case, contact technical support for
help.
B. If the MaxiVCI V150 is unable to establish a communication link, a prompt
message displays with check instructions. The following conditions are the
possible causes:
⚫ The MaxiVCI V150 is unable to establish a communication link with the
vehicle.
⚫ The system selected for testing is not equipped on the vehicle.
⚫ There is a loose connection.
⚫ There is a blown vehicle fuse.
⚫ There is a wiring fault of the vehicle or the adapter.
⚫ There is a circuit fault in the adapter.