62
➢ To print data in Diagnostics
1. Tap the Diagnostics application button from the MaxiTPMS Job Menu. The
Print button on the diagnostic toolbar is available throughout the whole
diagnostics operations.
2. Tap Print. A drop-down menu will be displayed:
⚫ Print This Page — prints a screenshot of the current screen.
⚫ Print All Data — prints a PDF file of all displayed data.
3. A temporary file will be created and sent to the connected PC for printing.
4. When the file is transferred successfully, a confirmation message will appear.
➢ To submit Data Logging reports in Diagnostics
1. Tap the Diagnostics application button from the MaxiTPMS Job Menu. The
Data Logging button on the diagnostic toolbar is available throughout the
whole diagnostics operations.
2. Tap the Data Logging button to display the error options. Select a specific
error, and a submission form will appear to let you fill in the report information.
3. Tap the Send button in the upper-right corner of the screen to submit the
report form via the Internet. A confirmation message will appear when sent
successfully.
5.4.1.2 Status Information Bar
The status information bar at the top of the main section may display the following
items:
1. Menu Title — displays the menu heading of the main section.
2. VCI Icon — displays the VCI connection status.
3. Voltage Icon — displays the vehicle’s voltage status.
5.4.1.3 Main Section
The main section of the screen varies according to the stage of operations, which may
display vehicle identification selections, the main menu, test data, messages,
instructions, and other diagnostic information.
5.4.1.4 Function Buttons
The displayed function buttons vary depending on the stage of operations. These
buttons can be used to navigate menus, to save or clear diagnostic data, to exit
scanning, and to perform a number of other control functions. The use of these buttons
will be discussed in detail in the following sections of the corresponding test operations.
To Next Page
Loading...
