IP Configuration
Issue 2 July 2005 171
Tip:
Tip: If the IP interface is on VLAN #1, continue with Step 7.
6. Create the management/routing VLAN. Use the command
set vlan <Vlan-id> name <Vlan-name> replacing <Vlan-id> by the VLAN number,
and <Vlan-name> by the VLAN name. Press Enter.
7. Create an IP interface name. Type:
Router(configure)# interface <interface-name>
Press Enter.
The Router(configure-if:<interface-name>)# prompt appears.
8. Assign the IP address and network mask of the IP interface you have created. Use the
command:
Router(configure-if:<interface-name>)# ip address <ip-address>
<netmask>
Press Enter
9. Assign a vlan to the IP interface you have created. Type: Assign a vlan to the IP interface
you have created. Type:
Router(configure)# interface <interface-name># ip vlan <vland-id>
Press Enter.
10. Type exit and press Enter. This returns you to the prompt: Router(configure)#
11. If the management station is not on the same subnet as the switch, configure a default
gateway (static route). Use the command:
ip default-gateway <ip-address> and press Enter, replacing
<ip-address> with the IP address of the default gateway.
12. Save the configuration changes by typing copy running-config startup-config
and press Enter.
To Next Page
Loading...
