Troubleshooting the Installation
Issue 2 July 2005 215
● Octaplane cables not
installed correctly
(LEDs on stacking
module do not light)
● Check that the cables are
inserted correctly
● Check that there are no
cross-corrections
● The pins on the
Octaplane cable are
bent or broken
● Replace the cable
● The socket on the
stacking module is
damaged
● Replace the stacking module
● NVRAM INIT jumper is
bridged
● Remove the stacking module and
then unbridge the jumper.
Table 35: Troubleshooting 3 of 3
Problem/Cause Suggested Solution
3 of 3
To Next Page
