67
d. Burn input / output firmware for the DVG card (required for I/O setup 1In 7Out):
dvgflash -board 0 -write xdcam_io_xxxx.bin
n
It is recommended to have all required firmware for each required format burned for each board.
e. Burn output/ output firmware for the DVG card:
dvgflash -board 0 -write xdcam_oo_xxxx.bin
f. Confirm burning of the listed firmware:
dvgflash -board 0 -reconf -list
5. Repeat the above step for each board.
To check the status:
1. Use vim to open the burning status file:
cat /tmp/burning_status
dvgflash -board 0 -reconf -list
Example:
SUCCESS
XDCAM
HD
2. To save and exit the file, type
:wq!
and press Enter.
3. Check the log file for any errors: /data/VS/bin/flash.log.
To Next Page
Loading...
