Installation and Setup 10
Enabling EUCON in Pro Tools
When you first connect your S3, you must enable EUCON in Pro Tools, EUCON subsequently remains enabled in Pro Tools unless
you disable it. To enable EUCON in other DAWs, see the documentation provided by the manufacturer.
To enable EuControl in Pro Tools:
1 Launch Pro Tools. If the Quick Start dialog appears, close it.
2 Choose Setup > Peripherals, and click the Ethernet Controllers tab.
3 Select Enable EUCON.
4 Click OK. You do not need to configure any other Ethernet Controllers settings. These settings do not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible hardware. When Pro Tools finishes scanning your
system, your controllers are ready to use with Pro Tools.
5 Proceed to Confirming EUCON.
Enable EUCON check box
If you have recently updated from an earlier version of Pro Tools, go to Optimizing EuControl After a Pro Tools Update.
To Next Page
Loading...
Need help?
General
