EuControl Software 62
Preferences
Footswitch
You can connect a footswitch to S3 for hands-free punch in/out. Connect a footswtich to the 1/4-inch footswitch input on the back
panel.
To configure the Footswitch in EuControl:
In the Footswitch section of the Preferences tab, click to select the desired Punch In and Punch Out assignments:
Record | Record
When the application is rolling, pressing the footswitch once punches into recording on record enabled tracks. Pressing the
footswitch again takes the track(s) out of record but does not stop the transport.
Record | Play
Pressing the footswitch once punches into recording on record enabled tracks. Pressing the footswitch again stops the record pass
(your DAW may or may not automatically take the track out of record on stop; see the documentation for your application).
Status
Shows whether the footswitch state is currently on or off.
S3 VCA Spill Zone
(Pro Tools | S3 Only)
These options determine VCA Spill behavior in Multi-Master Mode, as follows:
Channel Strips 1–8
When selected, up to eight VCA Masters are assigned to S3 channel strips 9–16. Members of the selected
VCA Master are spilled to channel strips 1–8 in banks of eight channels.
Channel Strips 1–12
When selected, up to four VCA members are assigned to S3 channel strips 13–16. Members of the selected
VCA Master are spilled to channel strips 1–12 in banks of 12 channels.
Shift + Fader Sets Level to 0dB
When enabled, holding SHIFT and touching a fader sets the fader to 0dB. Surface SHIFT-lock does not apply (Surface SHIFT
must be pressed).
Preferences tab
To Next Page
Loading...
Need help?
General
