System Failures 10-9
WARMSTART
Each IFD is capable of performing a warmstart from a fully
aligned condition when subjected to a power loss of less than 30
seconds. In this event, a warmstart box is displayed on the ADI
portion of the PFD page on the affected IFD. A “PLEASE
STANDBY” message in the warmup box is displayed for
approximately 2 seconds followed by the “ATTEMPTING QUICK
RESTART” message and its countdown. There is no requirement
to limit dynamic maneuvering during this warmstart attempt.
Note: Two warmstart attempts in a row without a successful
alignment between attempts will result in a full alignment attempt.
Warmstart Box
To Next Page