3-8 Ground Operations
USE OF THE ENGINE TAB
The engine tab of the SYS Page Function Key is designed to
provide all necessary engine, electrical and related system
information to enable safe operations. This page is commonly
used during engine start and before takeoff run-up operations.
Note that some aircraft do not display engine data on the IFDs.
There are two typical techniques during engine start and pre-
takeoff run-up. Putting the electronic checklist data on the lower
half of the PFD via the “CHKL” Page Function Key and viewing
the engine data in full screen format on the MFD via the “Engine”
tab of the “SYS” Page Function Key, OR, reverse that setup and
put the engine data on the lower half of the PFD and the
electronic checklist data in full screen format on the MFD. The
technique chosen is pilot preference.
Technique 1
Technique 2
To Next Page
Loading...
