SAFETY PRECAUTIONS AND INSTRUCTIONS
Some procedures in this manual require special safety considerations. In such cases, the text is emphasized with the
following symbols:
Indicates a hazardous situation, which, if not avoided, will result in death or serious personal injury.
WARNING
Indicates a hazardous situation, which, if not avoided, could result in death or serious personal injury.
Indicates a hazardous situation, which, if not avoided, could result in minor or moderate personal injury or
damage to property.
Basic Safety Recommendations
Before installing or using this product, read this instruction manual thoroughly. Only qualified personnel should install and/or
repair this product. If a fault appears, contact your distributor.
The electromagnetic flow meter is only suitable for the measurement of conductive fluids. The manufacturer is not liable for
damages that result from improper use or from use that is not in accordance with the requirements.
The meters are constructed according to state-of-the-art technology and tested operationally reliable. They have left the
factory in a faultless condition concerning safety regulations.
Installation
Do not place any unit on an unstable surface that may allow it to fall.
Never place the units above a radiator or heating unit.
Route all cabling away from potential hazards.
Isolate from the mains before removing any covers.
Setup and Operation
Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result in
damage, incorrect operation or loss of data.
RoHs
Our products are RoHs compliant.
Battery Disposal
The batteries contained in our products need to be disposed of per your local legislation according to
EUdirective2006/66/EG.
Safety Precautions and Instructions
MAG-UM-00219-EN-17 Page 5 June 2021
To Next Page
Loading...
Need help?
General
