USER INTERFACE
The M5000 amplifier is pre-programmed from the factory. No additional programming is necessary, however, for special
features, the meter can be programmed for specific requirements.
Function Buttons
All M5000 programming is accomplished using the three function buttons located on the
front of the amplifier. Screen navigation and digit and parameter selection is performed by a
combination of these three buttons.
The up-arrow button allows scrolling through nine menu screens. This button is also used to advance numerical digits to
change values, such as frequency, period and EP level as well as toggle on-off conditions and flow directions.
The right-arrow button allows digit selection from left to right and allows selecting either the top row of the display or the
bottom row (the bottom row is active when flashing).
The EXIT SAVE button allows the saving of changed values and conditions, toggling between the upper and lower display
lines and returning to a previous menu.
Access the Programming Menu
To access the measuring mode for parametering, please press the key up-arrow button as long as necessary until “Menue” is
displayed on the second line.
Select Programming
Now press right-arrow button to select this menu point.
User Interface
MAG-UM-00219-EN-17Page 24 June 2021
To Next Page
Loading...
Need help?
General
