The Braking System State &
Braking System Fault Warning
Light
The brake indicator light turns on when the parking
brake is applied or when the brake fluid level falls
below the specified level. Before driving the vehicle,
the parking brake shall be completely released and
the brake indicator light shall be turned off. If the
brake warning light is lit while driving, it implies a
weakened braking effect. Follow the operations
below and park the vehicle in a safe place:
● If you step on the brake pedal, when the braking
effect weakens, step on the brake pedal harder.
EPB
Manual application of EPB:
When the vehicle is stationary and the Start/Stop
button is in the "RUN" mode , pull up the
AUTOHOLD switch button to apply EPB to prevent
the vehicle from rolling. At this time, the red parking
lamp on the instrument cluster lights up.
Automatic application of EPB:
When the vehicle is in any gear state and the
Start/Stop button is placed in "OFF" mode, the
vehicle will automatically park, and the red parking
light on the instrument cluster will go on.
Secondary application of EPB:
In some special cases, the AUTOHOLD switch
button can be triggered upwards for 3 s with the brake
caliper clamped a second time when the car is already
parked. Manual release of EPB:
When the Start/Stop button is in "RUN" mode, press
the brake pedal and push down the AUTOHOLD
switch button to release the EPB. At this moment,
the red parking lamp on the instrument cluster
goes out.
To Next Page
Loading...
