● If you push down the AUTOHOLD switch
without pressing the brake pedal, the EPB
will not be released. The instrument cluster
display prompts "Please press the brake
pedal to release the EPB".
● After the vehicle with automatic gears stops
moving, apply EPB first, and then switch the
gearshift handle to the "P" gear position.
● In some special cases, if the EPB is not
required for parking, the AUTOHOLD
switch can be pushed down before the
Start/Stop button is switched off, and hold it
for more than 3 s before switching off the
whole vehicle power supply, and then the
vehicle will not apply the parking brake.
● When the transfer case is in 4L, the
transmission is in D/R position. If EPB
parking is used for a long time, the
instrument cluster display will prompt "If
parking is used for a long time, please switch
to P/N position". On a slope, the vehicle may
slip when the transfer case is 4L and the EPB
is used in D/R position. Please be careful.
When the transfer case is 4L, minimize the
use of EPB in D/R gear.
● If two or more wheel speed sensors fail and
the Start/Stop button is in "RUN" state, the
vehicle cannot be parked by pulling up the
AUTOHOLD switch. The instrument cluster
display prompts "If parking, please pull the
EPB switch for a long time after shutting
down the engine". When the Start/Stop
button is in the "OFF" state, pull up the
AUTOHOLD switch for 3 seconds to realize
parking.
● When the Start/Stop button is in "OFF"
state, if the EPB is released, the vehicle can
be parked by pulling up the AUTOHOLD
switch for 3 s.
● When the yellow indicator light on the
instrument cluster goes on, it indicates that
the EPB system is faulty. Please contact the
authorized dealership of BAIC ORV for
repair.
To Next Page
Loading...
