Switching operation of AVM interface
When the system is started, the default screen of the
system in non-R position is front view + AVM, which
can be switched to other views through gear position,
turn signal, or touch screen operation.
When the vehicle is in "R" position, the screen
defaults to a 2D rear view + AVM, where dynamic
(and static) guides are integrated. When turning the
turning wheel, the vehicle driving track will be
calculated according to the turning wheel angle, with
guides provided to assist the driver to park.
AVM setting
The AVM function can be set through the
infotainment screen.
● Body color setting.
● Model setup of transparency: the vehicle
transparency can be adjusted from opaque to full
transparency.
● Auxiliary style, you can choose to turn on or off
the tire path and body contour. The green line is
the tire line, the yellow line is the body line, the
auxiliary line will change according to the change
of turning wheel.
● Sensor display: sensor display style, 2D sensor or
3D sensor can be selected.
● Brightness adjustment: adjust the brightness of
AVM interface.
● Front sensor automatic ON: when the vehicle is
under 15 km/h and the function is turned on, the
front sensor is turned on and can detect the close
obstacle ahead.
● Intelligent trigger switching: the AVM can be
triggered automatically when the turn signals are
switched on and when the front sensor detects an
obstacle.
To Next Page
Loading...
