Turn on/off/exit ACC
When the cruise control mode is set to ACC in the
settings of infotainment screen:
● When the ACC is turned off, toggle the ACC
switch upward to turn it on. At this time, the white
ACC indicator light in the instrument cluster
goes on, and the ACC enters the standby state.
● When the ACC is turned on, toggle the ACC
switch upward to turn it off.
Activate ACC
When the ACC is in the ON state and the system
meets the activation conditions, toggle the cruise
control RES+ key up or the SET- key up to activate
the ACC.
At this moment, if the current speed is ≥ 30 km/h, the
current speed will be set as the target speed; If the
current speed is ≤ 30 km/h, set 30 km/h as target
speed. At this time, the green ACC indicator light in
the instrument cluster lights up and the ACC is
activated.
After the ACC is turned on, it shall normally
work only when the following conditions are
satisfied:
● Set cruise control mode to ACC in
infotainment screen settings.
● The gear position is in D position.
● The engine is in operating state.
● No EPB is applied.
● The brake pedal is not depressed.
● The ESC switch is not turned off.
● The vehicle runs stably and the EPB system
is not involved.
● The brake temperature is not too hot due to
frequent brake.
● All doors are closed, including the bonnet
and liftgate.
● The driver's seat belt is not unlatched.
● 0 ≤ Ego speed ≤ 150 km/h.
To Next Page
Loading...
