Balluff BVS HS-P Series - Page 26

26
2
Setup
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
2.6 Customizing
Configuration
Settings
2.6.1 Configure
Interface Settings
If after reading the interface barcode from the previous table, your installation requires you to
select options to further customize your reader, turn to the appropriate section for your interface
type in "Configuration Parameters" starting on page 31.
2.6.2 Global Interface
Features
See "Global Interface Features" on page 32 for settings configurable by all interface types.
2.6.3 Configuring Other
Features
If your installation requires different programming than the standard factory default settings, the
following sections of this manual allow configuration of non-interface-specific settings you might
require. Go to
Configuration Using Barcodes, starting on page 31 for a complete list of available
options.
2.6.4 Software Version
Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by reading the following label.
2.6.5 Self Test and
Statistics
The internal status of the reader can be accessed in COM interfaces giving the following com-
mand string through a Terminal Emulator program: $S,yX,s[CR] (corded reader only).
Transmit Software Version