Balluff BVS HS-P Series - Page 27

27
www.balluff.com
2
Setup
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
2.6.6 Resetting the
Product
Configuration to
Defaults
Restore Custom
Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some options
and want to restore the Custom Default Configuration that may have been saved in the reader,
scan the Restore Custom Default Configuration barcode below. This will restore the custom con
-
figuration for the currently active interface.
Restore Factory
Configuration
The "Restore Custom Default Configuration" command above is normally enough to restart the
machine from a known status (set in the factory or by the customer via configuration file). The
machine is set as it arrived to you from the factory or according to the custom configuration file
you loaded afterward.
If you want to permanently cancel the setup defined by the configuration file use "Restore Fac-
tory Configuration" on page 299 of this manual.
The programming items listed in the following sections show the factory default settings for each
of the menu commands. If no configuration file has been loaded, the above command restores
the factory default.
2.6.7 Set Date and
Time
NOTE
Custom defaults are based on the interface type. Configure the imager for
the correct interface before reading this label.
Restore Custom Default Configuration
1 Scan the Enter/Exit Programming barcode below to set date and time.
ENTER/EXIT PROGRAMMING MODE
2 Scan the Set Date barcode + six digits for
Year, Month and Day (YYMMDD) from Appen-
dix D: Keypad.
Set Date
Set Time
3 Scan Set Time + six digits for Hours, Min-
utes and Seconds (HHMMSS) from Appen-
dix D: Keypad.
4 Scan the Enter/Exit Programming barcode to complete.