5. Preparing the buttons
Both the LEDs of the Button and the LEDs of the Base Unit are blinking white. This means pairing is in progress.
The Base Unit automatically checks whether the s oftware of the Button is up to d ate. If not, the Base Unit updates the B utton
software. This may take more time.
During the pairing and update proc ess, a small status bar is display.
Image 5-2
Pairing me ssage
The result of the pairing process can be as follows:
- When the LEDs become static white, the Button is paired to the Base Unit, but no software update was ne eded. You c an
unplug the Button from the Base Unit.
- When the LEDs become static red, the Button is paired to the Base Unit and the software update has finished. You can unplug
the Button from the Base Unit.
Image 5-3
Pairing finished
2. Unplug the Button from the Base Unit.
The Button is now ready for use.
5.2 P re-install of the Launcher service
Launcher service pre-install
The C lickShare Launcher service can be pre-installed on your laptop or on c ompany level. How this is done depends on your IT
infrastructure.
When the L auncher s ervice is pre-installed, a launcher application runs in the background. W hen you plug the Button in your laptop,
the ClickShare application w ill be run from the Button au tomatically. There is no need to run the file from the Button.
The pre-installer can be downloaded from th e B ase Unit’s configurator.
Where to download the launcher installer?
The launcher service (installer) can be downloaded via the technical download section per dev ice from Bar co’s website
w
ww.barco.com/clickshare.
5.3 ClickShare launcher installer
Interactive setup
In this setup, user r uns the installer an d installs the ClickShare launcher to the computer after a ccepting EULA and spe cifying the
installation directory. Follow the instructions on
the displayed screens.
22
R5900023 CSE-200 11/04/2016
To Next Page
Loading...
Need help?
General
